Weed Eater FL20
Will Run for a few minutes and stalls
Had this item for a year, followed all the usual details in regards to gas, storage etc. Trimmer actually worked great until a week ago. I can start the unit but after 2-5 minutes the unit will shut down. Then it needs to cool down before you can run again. Seems like this is a common occurrence with this model
July 13, 2013
This is the worst piece of junk i have ever wasted my money on. The line is always getting stuck in the spool and I have to stop,,,cut it off,,and hope I can rewind it so it will work! I thought i couldnt go wrong with the weedeater brand...turns out I thought wrong!
June 19, 2013
An Average Tool
I've had this Weed Eater for about 5 years, but it was used rarely...maybe 30 times total. I didn't use it more because it always took a long time to warm up, even after a bit of tuning. But, once it got going the machine did the job well.
This spring, I took the time to adjust the carb and change the filters and it seemed to be running a bit better. But this past weekend, it developed another problem...the machine would stop running after about 10 minutes and it was nearly impossible to pull the line. Turns out the bearing at the cutting end of the shaft is burned up.
For as little as I've used the machine over the years, and with proper maintenance, I'm quite a bit disappointed that such a critical part failed that is irreplaceable without buying an entire lower shaft...and out of warranty.
I paid $70 for this machine...I can't honestly say I ever got my money's worth for it.
June 4, 2013
Reliable but some parts cheap
I've had it for 5 years and no real issues until now. Keep in mind I've used it very little during this time, about 10 times per year for no more than 15 minutes each time. The issue now is the trimmer starts then stops after a few seconds. After some troubleshooting, I've come to the realization the gas lines have rotted and will need replacement. The diaphragm may also need replacement as it apparently stiffens up after a few years and does not allow gas to flow properly. The parts will add up to over 25$ which is almost a third of what I paid for this trimmer. Another issue I've had after a year or so was the handle loosened and cannot be tightened. It may have been dropped in all fairness, but a testament to its somewhat poor construction. For low usage/small lawns, this is an acceptable trimmer so long as you know it will not last you several years without parts being replaced. If you're not a DIYer, skip this trimmer.
May 6, 2013
Made to be thrown out in the trash. Alcohol in the gas mix will eat the hoses off in the fuel tank and it will quit on you.This will not be covered in warrenty which will cost you more to fix than buying a new one.
April 12, 2013
Good for the price
This trimmer works but not before I had to buy a wrench to adjust the carburator. Not sure why I have never had to do this before but almost everyone who n=buys this one had to do it. Works awesome now that I adjusted the carb.
March 16, 2013
i have two fl20's and a new fl25. the fl20's where given to me by people saying i cant get them to start i but fuel in them pushed the primer a few times and choke on they started right up never had any problems i have a lawn care bis so i have bought lots of weed wackers most lasted me a week before dying i have had these for almost three years had them so hot there metal was turning red let them cool down and they where ready to go again. i will never buy any thing but a weedeater if mine every die on me
March 8, 2013
this product would not run
weedeater would start but would not idle. try to use but would die. adjusting gas flow was no help. gas was mixed perfectly. neighbor had same problem.
October 13, 2012